Winegard RM-9946 Provozní pokyny stáhnout pdf (Strana 10)

Installation requirements

FIGURE 1

FIGURE 3

To install the Winegard Automatic Digital Satellite Dish, check

with your RV dealer or manufacturer. Your RV may already be

pre-wired for this system, and/or may have a reinforced roof

area available.

1. Choose a location on the roof that will allow the dish

to raise and rotate without interference from other

roof-mounted equipment.

2. Roof space required for operation is 40”L x 20”W

minimum. Refer to Figures 1, 2, 3 and 5 for operating

parameters.

3. The unit must be level, within 3°, for best operation.

Use the hydraulic or manual leveling equipment on

your vehicle to level the roof as much as possible.

Before beginning installation: If the mounting area is

not level, you can use a roof wedge, Figure 4.

Winegard’s RW-5000 roof wedge that will correct tilt up

to 3.7°. For units with severely sloping roofs, more

than one wedge may be needed.

4. When choosing a location for the interior wall plate

controller, consider wiring, ease of viewing the infor-

mation and distance from your television set.

FIGURE 2

FIGURE 4

FIGURE 5

RW-5000 ROOF

WEDGE & GASKET

VEHICLE ROOF

33” DIAMETER

TURNING

CLEARANCE

28”

FRONT OF VEHICLE

CENTER ROOF LINE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Žádné komentáře

Winegard RM-9946 Provozní pokyny Strana 10